| 1 |
Type |
Dynamic speaker |
| 2 |
Dimension |
External diameter 10 mm |
| 3 |
Rated Input Power |
0.2 W |
| 4 |
Impedance |
8 ohm ¡Ó 15% at 2500Hz |
| 5 |
Resonance Frequency (Fo) |
1650 Hz ¡Ó 20% at Fo, 1V |
| 6 |
Sensitivity (S.P.L.) |
67dB(W/m) ¡Ó 3 dB at AVE 2.0K,2.2K,2.5K,2.8K(Hz). |
| |
|
80dB(0.2W/0.1m) ¡Ó 3 dB |
| 7 |
Frequency Range |
Fo - 20KHz |
| 8 |
Distortion |
Less than 10 % at 2500Hz 0.2 W |
| 9 |
Max. Input Power |
Must be normal at 0.5W white noise for 1 minute. |
| 10 |
Voice Coil |
Diameter 5.7 mm |
| 11 |
Magnet |
Rare earth permanent (Nd-Fe-B) magnet £X5.2x0.3mm |
| 12 |
Weight |
0.6g ¡Ó 5% |
| 13 |
Appearance |
Should not exist any obstacle to be harmful to normal operation;
damages, cracks, rusts and distortions, etc. |
| 14 |
Operation Test |
Must be normal at program source 0.2W |
| 15 |
Buzz, Rattle, etc. |
Should not be audible 1.26V sine Wave between Fo to 20KHz |
| 16 |
Polarity |
When positive voltage is applied to the terminal marked (+),
diaphragm should move to the front. |
| 17 |
Terminal Strength |
Capable of withstand 1kg load for 30 seconds without resulting
in any damage or rejection. |
| 18 |
Load Test |
0.2 W white noise is applied for 96 hours and satisfy the
test listed on item 05,06,13,15 |
| 19 |
High Temp. Test |
Keep 96 hours at +70¢J¡Ó3¢J and leave 3 hours in normal temperature
and then check |
| 20 |
Low Temp. Test |
Keep 96 hours at -20¢J¡Ó3¢J and leave 3 hours in normal temperature
and then check |
| 21 |
Humidity Test |
Keep 96 hours at + 60¢J¡Ó3¢J relative humidity 95% and leave
3 hours in normal temperature and then checked. |
